Contraindication: This product is contraindicated for use on persons under the age of 18 years. 'Contraindication: This product must not be used if skin lesions or open wounds are present.'

Troubleshooting Guide Troubleshooting Guide For SunMaster, Alpha Sun and Virtual Sun Tanning Beds Your new tanning bed is backed by the most comprensive warranty in the industry but even the best tanning bed needs maintenance or a spare part once in a blue moon. This guide covers many of the most common issues with just about any tanning bed and should help the home tanning bed owner deal with most problems without having to call for service. These answers deal with home tanning beds in general, but more specifically to the models above.

New tanning beds: Make sure it is plugged in. Believe it or not, that is the cause in most cases. Make sure the breaker is in the ON position. Make sure you are turning the timer enough to start the system.

If the tanning bed also has a power switch, make sure it is in the ON position, and try both positions just to be sure. Make sure all the connections from the bench to the canopy (and to the air cooling bar if so equipped) are connected tightly.

Some tanning beds will not operate unless all the panels are in place and the bed is in the CLOSED position, so read your owners manual and see if you have these safety devices. Make sure the bed is fully assembled and in the closed position and try again. If the tanning bed is 120V powered, try moving a lamp or similar plug in device to the outlet and plug it in to test it. If it doesn't work, then the problem isn't the tanning bed.

If you are familiar with a volt meter and have one handy, make sure there is power getting to the socket. If your tanning bed has an analog timer (twist knob style) make sure you turn it passed 5 minutes, then roll it back to the proper time if under 5 minutes. Make sure the knob is not pressed so hard into the tanning bed that it is jammed against the body of it. If your tanning bed has a digital timer, make sure you have selected the proper minute session and pressed the START button. Usually, this is due to low voltage. If you have a 230VAC tanning bed, make sure that the available voltage is at least 215VAC (preferabley 220 to 230VAC) with no load.

If you have 208 to 211VAC power (usually ONLY in a business building) then you will need a buck/boost transformer to boost the voltage to a proper level. If you have a 120VAC tanning bed, the voltage should be at least 110VAC (preferably 115-125VAC). If your incoming voltage is correct, the likely problem is insufficient wiring, ie: the gauge of the wire to the circuit is too small.

Often, a tanning bed needing 20AMP service, but run on 14ga wire will show 120VAC with no load, but drop to 95VAC when the tanning bed is on. Reshebnik po toe bichkov. (This can be tested with a volt meter) This is a dangerous situation and should be corrected by a licensed electrician. This is normal and will not affect the tanning of the lamp appreciably if the lamps are not older than 2/3rds of their rated life. Some installations seem to turn lamp ends dark after a few weeks, others do not, but the UV output of the lamps should be fine.

Some of the actions lack context since you haven't gotten to the story bit that fully explains them, but you're certainly allowed to play around. Black Flag drops you right in action and within 15 to 20 minutes, you're ready to do whatever you want on the high seas. I freed pirates from guards without a crew to send them to and pillaged a fort long before the game led me there by the hand. Download direct:- One thing Ubisoft did learn from Assassin's Creed III is skipping a lengthy opening tutorial section.